How to use the insert ventless interlligent bioethanol fireplaces?

Automatic Bioethanol fireplace insert Model

1.Install the fireplace steadly.
2.Link the power supply and plug the charger to the device.
3.Open the tank door,add moderate alcohol to stainless steel burner
4.Press the switch ON/OFF DURING 5 SECONDS or press on the remote control.after a few seconds an automatic ignition will take place.
5.Advantage ?
A . Cheaper  B . burner is with ceramic wool , its life is longer than common manul fireplace.

Notice:Add ethanol must shut the device and wait for the fireplace panel cooling.otherwise easy to cause fire!

For video of our bioethanol fireplaces,pls contact our sales to get it.Thanks!

Manual Operation of Igniting the bioethanol fireplaces:

insert bioethanol fireplace
insert bioethanol fireplace

1,Press the right button under the LCD during FIVE SECONDS.

insert bioethanol burner
insert bioethanol burner

2,The LCD will show the operating time.

insert ethanol fireplace
insert ethanol fireplace

3,the Pump will operate to pump the bioethanol into the trough of the fireplace.

insert alcohol fireplace
insert alcohol fireplace

4,Then the igniter will work to ignite the ethanol.

insert alcohol burner
insert alcohol burner

5,the temperature get above 78℃,it will ignite the ethanol.

For the first the fireplace is used,we suggest to fill up the tank until it is full.
Because when the burner is new,there is air inside the pump and the pipe,
so it is a little bit difficult for the pump to pump the ethanol to the fireplace Trough.
If the tank is full ,the pressure of the liquid could push the air out from the pump and the pipe,
then the pump can work normal.
So Our suggestion is to fill up the tank until it is full,and try to start the burner again.
If the problem still exists, you need to open the fireplace, the step is as below:
1.Clean all the ethanol out from the tank, make sure the tank is empty.
2.Lossen the screws which are used to fis the top plate and the black box.
3.Take the top plate out from the black box.But when you try to take the top plate out from the black box ,please
pay attention,because there is two wires connceted between the top plate and the black box,you need to disconnect these two wires.
4.The pump system is on the one side of the fireplace.The main problem is the air inside the pump,so Please try to push some liquid inside the pipe which is connected between the pump and the tank,then the pump could work normal.
For more informations,pls contact our sales
How to use the interlligent bioethanol fireplaces?